Author Topic: How to place a jumper on R1 for NHD-0420D3Z-NSW-BBW-V3  (Read 239 times)

Joe

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
How to place a jumper on R1 for NHD-0420D3Z-NSW-BBW-V3
« on: July 19, 2019, 04:41:27 PM »
The datesheet asks me to place a jumper on R1(another word is, make R1 short), may I know how to do it?  R1 is a hole.

Alee_S

  • Administrator
  • Jr. Member
  • *****
  • Posts: 50
  • Karma: 0
    • View Profile
Re: How to place a jumper on R1 for NHD-0420D3Z-NSW-BBW-V3
« Reply #1 on: July 22, 2019, 10:25:41 AM »
Hi Joe,

R1 and R2 are the unpopulated pads located just above the labeling, as shown in the attachment. However I do understand the confusion, as it's located next to 2 other hole slots.
You may then solder an 0603 0-ohm SMT resistor to create the short between the two pads.

Best,

 

RS232 PIC CCS COMPILER COMANDS FOR NHD-0420D3Z-NSW-BBW-V3 ISSUE

Started by DavidVMBoard Character LCDs

Replies: 2
Views: 3826
Last post May 30, 2017, 12:58:32 PM
by DavidVM
NHD-0420D3Z-NSW-BBW-V3 i2c display and Arduino missing characters

Started by 0miker0Board Character LCDs

Replies: 0
Views: 5504
Last post July 06, 2017, 11:05:59 AM
by 0miker0
NHD-0420D3Z-NSW-BBW-V3_revB has strange behavior through SPI with Raspberry Pi

Started by VATHBoard Character LCDs

Replies: 0
Views: 1452
Last post June 13, 2018, 10:41:46 AM
by VATH
NHD-0420D3Z - Arduino I2C Address 0x28 SOLVED

Started by andywbBoard Character LCDs

Replies: 1
Views: 2034
Last post August 11, 2018, 01:24:36 AM
by andywb
NHD-0420D3Z-NSW-BBW-V3 back-light flickers

Started by rickford66Board Character LCDs

Replies: 3
Views: 5882
Last post May 06, 2015, 08:34:09 AM
by fraryb