Author Topic: NHD‐C0220AA‐FSW‐FTW Contrast  (Read 2813 times)

mhathaway

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
NHD‐C0220AA‐FSW‐FTW Contrast
« on: February 25, 2015, 06:14:11 PM »
I am using the NHD‐C0220AA‐FSW‐FTW and it works great on my first board.  I am trying to get a second board up (same PCB design, same software), but the nothing come on the LCD.  I think that it's a contrast problem but no matter what voltage I put on pin #2 (3.3V down to .013V) I can't see my text.  Here are the voltages on my pins:
1. 0V (gnd)
2. adjustable, but trying 0.1V and lower
3. 3.3V
4. Mostly 3.3V (brought low during instructions, but defaults at high)
5. 0V (gnd)
6.  Mostly low, brought high during messages
7-14. Parallel message.

Any ideas on what i should try?

Retheesh_M

  • Guest
Re: NHD‐C0220AA‐FSW‐FTW Contrast
« Reply #1 on: March 03, 2015, 11:53:43 AM »
For pin 6, you should start at high and then bring it low during messages.  The timing diagram on page 8 of the specification sheet shows how the Enable pin (E) should go high first and then low.  Also if you are checking the busy flag during initialization, it is recommended to use a delay instead because this controller is known to have issues with the busy signal as noted on page 5 of the specification sheet.

 

Setting contrast using component pads on LCD module - NHD-24064WG-ATMI-VZ

Started by ngatgiBoard Graphic LCDs

Replies: 1
Views: 702
Last post April 04, 2018, 07:08:38 PM
by ngatgi
NHD-2.7-12864UCY3 brightness/contrast adjusting

Started by EK701Board OLEDs

Replies: 3
Views: 4295
Last post January 28, 2016, 09:51:31 AM
by Saurabh_B
software controlled contrast is not consistent

Started by pabbottBoard Character LCDs

Replies: 2
Views: 3059
Last post September 10, 2015, 02:17:08 PM
by pabbott
NHD-0108CZ-FSW-GBW-33V3 contrast voltage

Started by perkyBoard Character LCDs

Replies: 3
Views: 3390
Last post February 12, 2016, 04:01:29 PM
by perky
MOVED: Problem of contrast NHD-0216K1Z-NSW-BBW-L

Started by Saurabh_BBoard Graphic LCDs

Replies: 0
Views: 1947
Last post January 24, 2017, 08:36:08 AM
by Saurabh_B