Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Bobec

Pages: [1]
Character LCDs / NHD-0216K3Z-FL-GBW-V3-C serial interface not working
« on: July 13, 2015, 02:27:30 PM »
I hooked two of these displays up to RS232 at 9600 and get a bunch of junk characters. To test my output stream I routed the serial output to hyperterminal and the stream is correct. I tried changing the baud rate to everyone listed in the data sheet and still a bunch of junk. These displays all show evidence of once being setup, before I received them, for I2C because there is solder and flux on and around the R1 pads.

Any advise?

Pages: [1]