Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Chruetli

Pages: [1]
1
Character LCDs / Re: NHD-C0220Biz-FS(RGB)-FBW-3VM initialization problem
« on: December 07, 2017, 07:18:41 PM »
Solved, the 2.2k poll-up was the root of the evil. Removed from the demo board and replaced by an external 10k, all is doing right!! Those 10k are pretty important...

2
Character LCDs / Re: NHD-C0220Biz-FS(RGB)-FBW-3VM initialization problem
« on: December 03, 2017, 02:59:51 AM »
Hmm, just found out that my dev board has 2.2k pull-up on SCL and SDA lines - instead of 10k as recommended. But my logic analyzer show all commands as expected...

3
Character LCDs / NHD-C0220Biz-FS(RGB)-FBW-3VM initialization problem
« on: December 01, 2017, 02:40:04 PM »
I'm using an embedded Linux system - with a dedicated I2C bus - to drive a "NHD-C0220Biz-FS(RGB)-FBW-3VM" display. The Linux kernel module supplies an I2C master, so I do not have to bit bang.
Using 'i2c_master_send(...)' does the addressing, clocking and so on. Most calls work but 0x39 and 0x01 don't work...
0x0  -> ok
0x38 -> ok
0x39 -> fail
0x14 -> ok
...
0x0c -> ok
0x01 -> fail
...


I also tried to make 2 byte packets {0x0, 0x?} and send them together but the same commands failed. And there is no visible reaction on the display.
Any sugestins?

Pages: [1]