Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - wedge

Pages: [1]
Character LCDs / OLED Character display - Some commands don't work
« on: July 06, 2014, 12:52:19 AM »
I'm using a NHD-0216KZW-AY5 in 4-bit parallel mode, using the busy signal (not using blind delays).  The device initializes just fine, and prints text to the screen successfully.
However, the screen does not respond to the Clear Screen command, and the Move Cursor command.  It simply does nothing when those commands are sent.  There may or may not be other commands it's not responding to, but those are the only ones I've noticed.

If I swap out the screen for any other HD44780 compatible, and leave all other code and connections exactly the same, then everything is working perfectly.

Pages: [1]