Author Topic: NHD-0116AZ-FL-YBW enable backlight  (Read 2188 times)

jonbhanson

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
NHD-0116AZ-FL-YBW enable backlight
« on: August 22, 2014, 03:41:05 PM »
I have a NHD-0116AZ-FL-YBW with a backlight that does not come on.  As I ohm out the back of this display, it looks like the power is going to jumpers and resistors that I need to populate in order to enable the backlight.  However, I can't find a description of these jumpers and resistors anywhere in the product documentation.  Can you please instruct me? Thanks!

Jon

Michael_L

  • Administrator
  • Hero Member
  • *****
  • Posts: 356
  • Karma: 33
    • View Profile
Re: NHD-0116AZ-FL-YBW enable backlight
« Reply #1 on: August 26, 2014, 04:25:30 PM »
Have you purchased this display recently?  The display should already come with the backlight connected, and correct pads populated.
I'm assuming this is an older display of ours, in which case to use this backlight in the same way you would need to solder a 6.8Ω resistor on solder pad R8.

 

Backlight brightness with TFT displays (5" and 7")

Started by dsheroBoard TFTs

Replies: 3
Views: 2932
Last post July 21, 2015, 07:19:42 AM
by Michael_L
NHD-7.0-800480EF-20 Controller Board and the backlight on a 800x480 LCD Display

Started by dfanslerBoard TFTs

Replies: 1
Views: 2440
Last post July 27, 2015, 10:08:23 AM
by Saurabh_B
MOVED: NHD-0 420D 3Z- FL-GBW Backlight brightness won't change .

Started by Saurabh_BBoard Graphic LCDs

Replies: 0
Views: 2036
Last post November 17, 2015, 11:25:04 AM
by Saurabh_B
MOVED: NHD-24064WG-AYYH-V Backlight current

Started by Saurabh_BBoard Character LCDs

Replies: 0
Views: 1869
Last post May 18, 2016, 08:00:24 AM
by Saurabh_B
NHD-7.0-800480EF-ASXN#-CTP: Nominal Backlight Current

Started by emilzachariaBoard TFTs

Replies: 1
Views: 715
Last post February 20, 2017, 08:25:44 AM
by Saurabh_B