Author Topic: LCD : NHD-0216K3Z-NSW-BBW-V3 -- Firmware version clarification  (Read 2223 times)

amitatt

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
I am currently using the New Haven LCD p.no. NHD-0216K3Z-NSW-BBW in one of our application. while ordering the same display from vendor I was told that the display is obsolete and the following LCD p.no. NHD-0216K3Z-NSW-BBW-V3 is available. I have compared the datasheet of these two parts and the new part has a new firmware version V3.
Could you confirm, that the software I have written for the earlier LCD: NHD-0216K3Z-NSW-BBW will work with new LCD: NHD-0216K3Z-NSW-BBW-V3 without any modification.

Thanks in advance

Michael_L

  • Administrator
  • Hero Member
  • *****
  • Posts: 356
  • Karma: 33
    • View Profile
Re: LCD : NHD-0216K3Z-NSW-BBW-V3 -- Firmware version clarification
« Reply #1 on: August 26, 2014, 04:27:41 PM »
Your software should still work fine, depending on the interface you are using.  If you are using I2C, the timing will need to be adjusted slower to work with the newer firmware.  This is currently being revised to be able to run at the same speed as the previous version.  If you are using SPI or RS-232, the timing will be the same.

 

NHD-0216K3Z-FL-GBW-V3 losing/dropping characters

Started by SaintGimpBoard Character LCDs

Replies: 1
Views: 2810
Last post April 07, 2014, 08:57:01 AM
by Michael_L
NHD-0216K3Z-FL-GBW-V3-C serial interface not working

Started by BobecBoard Character LCDs

Replies: 1
Views: 1842
Last post July 14, 2015, 08:49:25 AM
by Saurabh_B
NHD-0216K3Z-FL-GBW-V3 outputting 5V on data pin

Started by Andrew_BBoard Character LCDs

Replies: 4
Views: 955
Last post December 07, 2016, 08:34:51 AM
by Paul_B
NHD-0216K3Z-FL-GBW-V3 via SPI Help Requested

Started by milheadBoard Character LCDs

Replies: 4
Views: 3975
Last post May 06, 2014, 12:07:10 PM
by Michael_L
Help!!-NHD-0216K3Z-FL-GBW-V3 not working

Started by JackBoard Character LCDs

Replies: 2
Views: 2063
Last post April 25, 2016, 11:31:36 AM
by Jack