Author Topic: FT5x06 Initial Register Values  (Read 1420 times)

rproesel

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
FT5x06 Initial Register Values
« on: January 12, 2016, 05:53:51 PM »
I am using a 4.3" display with the FT5x06 touch controller.  After power-up reset without touching the screen, the registers contain values that indicate at least 1 touch point active and the event flags indicate a "contact" condition.  Sometimes it will power-up indicating more than 1 touch point.  After I touch the screen once, the registers all indicate properly.  I have tried 2 different displays with the same results.

I have tried resetting the display using the reset line, but nothing changes.  It will only indicate properly after I touch the display.

Have you seen this?

 

NHD-3.5-320240MF-ATXL#-CTP-1 Ft5x06 Linux device tree

Started by rajarajan.rBoard TFTs

Replies: 1
Views: 2289
Last post July 05, 2016, 01:21:43 PM
by UART
Capacitive touch problems under linux (FT5x06)

Started by vpdBoard TFTs

Replies: 20
Views: 19400
Last post July 23, 2014, 02:01:31 AM
by vpd
Question about FT5x06 controller (NHD-7.0-800480EF-ATXL-CTP)

Started by DominusDRRBoard TFTs

Replies: 5
Views: 3584
Last post May 15, 2015, 10:04:11 AM
by DominusDRR
[SOLVED] FT5x06 Event Flag Put Up

Started by PaulVdBerghBoard TFTs

Replies: 3
Views: 3071
Last post September 04, 2014, 04:41:55 AM
by PaulVdBergh
Problem setting "function select c" register

Started by jonmon6691Board OLEDs

Replies: 3
Views: 2147
Last post May 04, 2016, 02:44:37 PM
by Saurabh_B