Author Topic: Touch Screen - NHD-2.4-240320SF-CTXL#-FTN1  (Read 2651 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
Touch Screen - NHD-2.4-240320SF-CTXL#-FTN1
« on: November 19, 2014, 11:10:02 AM »
Hi Srs,

I would like to know if it is possible to supply touch screen of NHD-2.4-240320SF-CTXL#-FTN1 display, with 3.3V instead of 5V. Is it work?


Marcelo Rilko


  • Administrator
  • Hero Member
  • *****
  • Posts: 356
  • Karma: 33
    • View Profile
Re: Touch Screen - NHD-2.4-240320SF-CTXL#-FTN1
« Reply #1 on: November 20, 2014, 09:16:09 AM »
Yes it will work.  The resistive touch panels are simply voltage dividers when pressed at a certain location.  There is no IC or chip that is being powered.  Normally with 5.0V you would get near 0V when touching one end of the touch panel, and near 5.0V when touching the other end, with all the voltage levels in between representing you location.  With 3.3V, it will work the same, except it will be from 0 - 3.3V. You will need to test it to ultimately decide if it works for you.


  • Newbie
  • *
  • Posts: 3
  • Karma: 0
    • View Profile
Re: Touch Screen - NHD-2.4-240320SF-CTXL#-FTN1
« Reply #2 on: November 23, 2014, 10:07:16 AM »
I'm currently using the touchscreen with voltage from a Li-Ion cell (3V - 4.2V)(VBAT).  Seems to be working fine.  I just have my ADC referenced to GND and VBAT so it simply measures the touchscreen output as a ratio of VBAT.  The only variance from what marcelocrr said is that my readings only range from about 0.3V (probably due to the input buffer offset) and about 0.6VBAT (not sure why this isn't full range). 


NHD‐3.5‐320240MF‐ATXL#‐T‐1 Touch Signal

Started by jmasamotoBoard TFTs

Replies: 1
Views: 2627
Last post February 05, 2016, 08:05:40 AM
by Paul_B
NHD-5.0-800480TF-ATXL#-T and NHD-5.0-800480TF-20 Controller Board No Touch?

Started by dfanslerBoard TFTs

Replies: 5
Views: 1765
Last post May 26, 2017, 11:10:57 AM
by Saurabh_B
Shift position after "clear screen" instruction

Started by dreissBoard OLEDs

Replies: 5
Views: 3696
Last post September 18, 2015, 03:50:30 PM
by Saurabh_B
7.0" TFTs with capacitive Touch and 8080 interface availability?

Started by gdoraisaBoard TFTs

Replies: 1
Views: 1735
Last post June 30, 2016, 07:54:11 AM
by Saurabh_B
NHD-4.3-480272EF-ASXN#-CTP touch controller interrupt signal

Started by Chris ElectronicsBoard TFTs

Replies: 2
Views: 2887
Last post May 20, 2016, 07:38:45 AM
by Chris Electronics