Author Topic: Interface to 3.6 volt MCU  (Read 2440 times)

radio

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
Interface to 3.6 volt MCU
« on: April 27, 2014, 10:30:56 AM »
I have an NHD-0216BZ-FL-YBW display which I want to control with a microcontroller. The microcontroller operates from 3.6 volts. I plan to ground thr R/W pin, so the display is always in Write mode. I'm concerned about the DB4 - DB7 pins; if the driver chip in the display pulls up to +5 volts, this could potentially damage the microcontroller. Is this the case?

The driver datasheet isn't very clear on this point. I can add level-shifting circuitry if needed, but would prefer not to.

Thanks
Bob

Michael_L

  • Administrator
  • Hero Member
  • *****
  • Posts: 356
  • Karma: 33
    • View Profile
Re: Interface to 3.6 volt MCU
« Reply #1 on: April 29, 2014, 10:10:01 AM »
That display should not be powered with less than 4.7V as indicated in the spec.  This goes for VDD and also the logic levels.  As for the data lines, the voltage is determined by the microcontroller when writing to the display only.

 

NHD‐0420CW‐AB3 I2C Interface

Started by andersonpdBoard OLEDs

Replies: 1
Views: 2730
Last post January 23, 2015, 10:00:06 AM
by Michael_L
NHD‐0420DZW‐AY5 SPI Interface

Started by vinaykBoard OLEDs

Replies: 0
Views: 2124
Last post October 26, 2015, 05:13:10 AM
by vinayk
NHD‐3.12‐25664UMB3 3 or 4 wire interface

Started by cliffgBoard OLEDs

Replies: 1
Views: 2560
Last post February 13, 2015, 04:43:21 PM
by Michael_L
NHD-2.4-240320CF-CTXI#-FT (ST7789S controller) and STM32F4 FSMC LCD Interface

Started by deshayesBoard TFTs

Replies: 1
Views: 2759
Last post March 17, 2016, 06:25:18 PM
by fahad
7.0" TFTs with capacitive Touch and 8080 interface availability?

Started by gdoraisaBoard TFTs

Replies: 1
Views: 1332
Last post June 30, 2016, 07:54:11 AM
by Saurabh_B