Custom Motorcycle Instrumentation

[MyNameIsMud]

Hi,

Decided to share a hobby project I've been working on lately.

Its a custom instrumentation for a turbocharged Suzuki Hayabusa. It uses two NHD-0420CW-AR3 OLED displays, showing the speed, rpm and other sensor data. The software development is ongoing but the basic layout can be seen from the pics.

The cover lens also has warning lights integrated to it, the cover lens print openings have been done using Laser. There is also a ambient light sensor sniffing the Lux level.

The casing is black anodized aluminum, and the machining marks on the front bezel have been designed to create some visual effect.

The gauge is connected to a self made control unit which communicates with the engine management unit and water injection system.


--
Lassi

[attachment deleted by admin]

[Paul_B]

Brilliant, thank you for sharing Lassi! Are you pulling the data via the SDS port?

[MyNameIsMud]

Brilliant, thank you for sharing Lassi! Are you pulling the data via the SDS port?

Thanks Paul!

I´m using 4-bit parallel port with the displays + additional lines for the chip select, seems to be working nicely.

The gauge control box reads EMU PWM signals for speed and tach, also a couple of separate EMU AUX ports for sensor data so no serial data there either. The water injection system has its own control system which gives out warnings for low water etc. The gauge control box has few of its own sensors also.

Wanted to make the code as simple and robust as possible to avoid issues with critical systems, also wanted to build the gauge and control box so that if they fail, it will not have an effect on the other systems, you just don't see any readings.

Have to say, its been a real learning experience for a mechanical engineer... DOH! Though the displays seem to be tough - they have held up nicely all kind of handling and mishaps!

--
Lassi

[GeorgeE]

thank you for sharing Lassi