Newhaven Products > Evaluation Tools

Unable to detect NHdev board target using J-link

(1/1)

jandrade:
Hello. I am trying to re-program the NHdev board but the target is not being recognized using J-link from SEGGER. The touch screen display is working fine and I am able to see the images loaded from the SD card. I was able to successfully use the J-Link on another board (not from New Haven) with no problems. Here's the equipment I have.


* NH Development Board w/ STM32F103RET6 ARM 32 bit Cortex-M3
* NHD-2.4-240320CF-CTXI#-FT
* SEGGER J-Link Base programmer
Here's a screenshot from the J-link command. You can see the version of Jlink being used.



http://imgur.com/Rz2APHD


As you can see, it cannot detect the target. I tried scanning the target using MDK Keil uVision 5 as well but same result. Any feedback would be appreciated.

Navigation

[0] Message Index

Go to full version