Author Topic: B/W cursor problem on NHD-0420CW-AB3  (Read 640 times)

BobG

  • Newbie
  • *
  • Posts: 8
  • Karma: 0
    • View Profile
B/W cursor problem on NHD-0420CW-AB3
« on: March 02, 2017, 04:20:07 PM »
I'm running this display using 100KHz I2C at 5V (Iv'e also tried 3.5V) and am not observing any data corruption problems.  But I am having trouble with the operation of the B/W bit in the Extended Function Set.  If I write data on the display, then position the cursor over an existing character, then turn on the cursor (Display on with C set), the character is underlined as expected.  If I now issue an Extended Function Set with the B/W bit set, I expect to see the character image pixels inverted (on <-> off).  In fact, what I see is the cursor line vanish and the character stays the same.  If I issue another Display on with C and B set, the entire block alternates between all on (block) and the original character (cursor line still absent). If I now issue an Extended Function Set command with the B/W bit cleared, I get a display with the character alternating with a full-on block - with the cursor line on steady beneath it.  If I turn off the cursor and the blink, then changeing the B/W bit has no visible effect.  This doesn't seem to agree with the description in the manual.  What's happening?

 

NHD‐0420CW‐AB3 I2C Interface

Started by andersonpdBoard OLEDs

Replies: 1
Views: 2629
Last post January 23, 2015, 10:00:06 AM
by Michael_L
NHD‐3.5‐320240MF‐ATXL#‐CTP‐1 Problem with standby mode

Started by guenterBoard TFTs

Replies: 0
Views: 1935
Last post June 16, 2016, 12:14:36 PM
by guenter
NHD‐0420CW‐AG3 Contrast question

Started by RichardRBoard OLEDs

Replies: 2
Views: 2143
Last post January 16, 2016, 09:52:02 AM
by RichardR
NHD‐0420CW‐AG3: blinking part of text?

Started by RichardRBoard OLEDs

Replies: 2
Views: 2298
Last post February 28, 2017, 03:27:02 PM
by BobG
NHD‐0420CW‐AG3 + I2C + PIC assembly code: trouble getting started

Started by RichardRBoard OLEDs

Replies: 4
Views: 3137
Last post December 17, 2015, 03:12:49 AM
by RichardR