Author Topic: How work with NHD-0216AW-SB3  (Read 3526 times)


  • Guest
How work with NHD-0216AW-SB3
« on: May 17, 2017, 05:40:13 AM »
Good afternoon! I want to use the NHD-0216AW-SB3 display in my design, but having looked at the instruction set I do not understand how to form them. For example, D / C #, R / W # signals for displays with a SPI interface are not available at all. Is the correct datasheet posted on the site for this display? Is it necessary to somehow generate signals IS, RE, SD?


  • Administrator
  • Hero Member
  • *****
  • Posts: 385
  • Karma: 10
    • View Profile
Re: How work with NHD-0216AW-SB3
« Reply #1 on: May 17, 2017, 04:30:14 PM »
Hello Racurs,

The datasheet is set up properly. The D/C# and R/W# bits are set when sending the initial data.
The information for this can be found on page nine of the controller datasheet (LINK).

Please also note that when sending data to this display I you do need to break each byte into half and send 4 bits at a time. This is also explained on page ten of the controller datasheet linked above.


NHD-5.0-800480TF-ATXL#-CTP why don't typical timing values work?

Started by jkelleherBoard TFTs

Replies: 2
Views: 4976
Last post August 31, 2015, 05:08:45 AM
by jmag999
OLED Character display - Some commands don't work

Started by wedgeBoard Character LCDs

Replies: 1
Views: 5579
Last post July 08, 2014, 09:29:43 AM
by Michael_L
Graphic LCD 128x64 LCD-00710 Doesn't Work

Started by robinsennyBoard Graphic LCDs

Replies: 0
Views: 899
Last post July 12, 2018, 08:35:53 AM
by robinsenny
NHD-0216AW-SB3 - issue with writing characters to screen

Started by kokomojoeBoard OLEDs

Replies: 0
Views: 624
Last post September 09, 2018, 07:29:49 PM
by kokomojoe
Help Getting ArduinoPro Mini 3.3V and NHD-C12864A1Z-FSW-FBW-HTT to work via SPI

Started by dalemooreBoard Graphic LCDs

Replies: 5
Views: 4130
Last post September 23, 2016, 07:44:35 AM
by Paul_B