Author Topic: Get Cursor Position Command  (Read 3115 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
Get Cursor Position Command
« on: September 27, 2017, 01:58:29 PM »

I am using the Serial Liquid Crystal Display Module (4 lines by 20 characters).  It would be very nice if there was a command that would return the cursor position.  This would allow me to handle user input from the keyboard when the entry is more than 20 characters long.  Currently the data wraps to wrong line.  If I knew where the cursor was I could re-position it in those cases.



  • Administrator
  • Jr. Member
  • *****
  • Posts: 15
  • Karma: 0
    • View Profile
Re: Get Cursor Position Command
« Reply #1 on: June 06, 2018, 05:05:19 PM »
Thank you for your feedback. We will certainly take this into consideration for the future designs. As a solution to your current problem, have you though about creating a write routine which a the end of sending the character string returns the cursor to a known position?


NHD-C0220BiZ Sometimes Ignoring "Clear Display" Command

Started by dstoverBoard Character LCDs

Replies: 2
Views: 8164
Last post March 27, 2014, 05:41:27 PM
by Michael_L
OLED Display Off Command

Started by AngeloRBoard OLEDs

Replies: 3
Views: 6126
Last post June 16, 2014, 05:45:42 PM
by Michael_L
ILI9341 Command Delay

Started by brybotBoard TFTs

Replies: 2
Views: 6007
Last post November 23, 2014, 10:32:09 AM
by PeterT
What hex command to invert text

Started by andysBoard OLEDs

Replies: 5
Views: 6452
Last post November 26, 2015, 11:08:32 PM
by swadhin
NHD-0216MW-IB3 Command Decoder

Started by BumpSplatBoard OLEDs

Replies: 4
Views: 2730
Last post August 20, 2019, 11:53:32 PM
by Dennis_GH