Author Topic: FT5336 problem with sensitivity and gesture  (Read 24 times)

tiro

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
    • View Profile
FT5336 problem with sensitivity and gesture
« on: October 16, 2017, 04:47:53 PM »
At first... hello all. I try to run display with this CTP but pdf are poor...
Now, small problem. Gesture register still give back 0, no matter what I draw by finger. It's normally?
And here is my big problem. I have three display, one work ok, but other two rages when I only touch it. FT cannot decide that I touch it by one or more finger, similar is with XY position. Is possible to adjust senstivity or change treshold point?

I find also pdf for FT5306 where I see register 0xA6h (firmware). In good module I see here 7, in bad is 6. But I'm not sure that is good way to read this register who I don't see in screen pdf (where is not write directly but is on FT5336)

Saurabh_B

  • Administrator
  • Hero Member
  • *****
  • Posts: 341
  • Karma: 10
    • View Profile
Re: FT5336 problem with sensitivity and gesture
« Reply #1 on: October 17, 2017, 09:25:50 AM »
I'm sorry you are having troubles with the display.

Do you have a datecode printed on those cables for the CTP?

 

NHD‐3.5‐320240MF‐ATXL#‐CTP‐1 Problem with standby mode

Started by guenterBoard TFTs

Replies: 0
Views: 1843
Last post June 16, 2016, 12:14:36 PM
by guenter
NHD‐2.4‐240320SF‐CTXL#‐FTN1 touch-screen problem

Started by hbcelebiBoard TFTs

Replies: 5
Views: 3976
Last post December 10, 2014, 11:19:05 AM
by Michael_L
Working on NHD‐2.4‐240320SF‐CTXL#‐FTN1, have problem in initialization

Started by sli25Board TFTs

Replies: 6
Views: 3610
Last post June 04, 2015, 09:52:25 PM
by sli25
Problem in bringing up NHD‐2.4‐240320SF‐CTXL#‐FTN1 on Renesas RL78/G14

Started by sli25Board TFTs

Replies: 3
Views: 2905
Last post May 28, 2015, 02:59:03 PM
by Michael_L
problem with NHD‐2.23‐12832UCB3

Started by luisvalsecaBoard OLEDs

Replies: 1
Views: 793
Last post January 24, 2017, 02:52:53 PM
by Saurabh_B