Author Topic: Any issue powering the NHD-C12864WO-B1TFH#-M from 3.3V?  (Read 1482 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
Any issue powering the NHD-C12864WO-B1TFH#-M from 3.3V?
« on: February 27, 2018, 07:47:11 AM »
the datasheet says it can be powered between 2.7V and 3.3V:

The microcontroller is powered from 3.3V, I would like to use a single power source for both.

Since I want to use it in an always-on application, I would like to know if there are potential issues (or something I should be aware of) using 3.3V power, or if 3.0V is recommended and I'll have to use a voltage translator.



  • Administrator
  • Full Member
  • *****
  • Posts: 79
  • Karma: 3
    • View Profile
Re: Any issue powering the NHD-C12864WO-B1TFH#-M from 3.3V?
« Reply #1 on: February 27, 2018, 09:03:40 AM »
The NHD-C12864WO-B1TFH#-M display can be powered safely by 3.3v so a single power source can be used for your application.


3 Volt to 3.3 Volt longterm reliability issue

Started by muragavinoBoard OLEDs

Replies: 1
Views: 3980
Last post November 11, 2014, 03:04:04 PM
by Michael_L
NHD-0216CW-AY3 8-bit Parallel 8080, Text on Display Issue

Started by forteyBoard OLEDs

Replies: 14
Views: 12628
Last post March 09, 2015, 02:23:51 PM
by Retheesh_M
Issue with reading busy flag in 4 bit mode.

Started by SwemarvBoard Character LCDs

Replies: 6
Views: 8448
Last post September 26, 2015, 10:12:49 AM
by acain829

Started by DavidVMBoard Character LCDs

Replies: 2
Views: 3227
Last post May 30, 2017, 12:58:32 PM
by DavidVM
Arduino FTDI_FT801 Library Documentation Issue

Started by stumpr84Board TFTs

Replies: 0
Views: 1851
Last post January 12, 2018, 01:46:50 PM
by stumpr84