Author Topic: Can't connect to NHDev via JTAG interface  (Read 165 times)

SteveK

  • Newbie
  • *
  • Posts: 4
  • Karma: 0
    • View Profile
Can't connect to NHDev via JTAG interface
« on: June 28, 2018, 06:07:48 PM »
Hi there,

I am trying to access the programming interface on the NHDev board using an STMicro ST-LINK programmer.

I am aware of a note in a previous (2015) topic:
The Dev board code disables the JTAG after a second of power, so
when loading the code you must hold the board in reset and program
immediately after letting off the reset button.


OK, so I do this, trying various delays between lifting the reset button and clicking "connect" on the ST-LINK.  I cannot make it connect - it reports "No Target Detected", or "Internal command error" if I keep the reset button down for longer.

Also in the previous topic, you stated that you use the Keil ULINK programmer, but at over $300, that's not an option at this stage.

Has anyone had success with the ST-LINK? Or, has anyone had success with an alternative but affordable programmer?

Many thanks,
Steve


 

NHD‐0420CW‐AB3 I2C Interface

Started by andersonpdBoard OLEDs

Replies: 1
Views: 3974
Last post January 23, 2015, 10:00:06 AM
by Michael_L
NHD‐0420DZW‐AY5 SPI Interface

Started by vinaykBoard OLEDs

Replies: 0
Views: 3174
Last post October 26, 2015, 05:13:10 AM
by vinayk
NHD‐3.12‐25664UMB3 3 or 4 wire interface

Started by cliffgBoard OLEDs

Replies: 1
Views: 3570
Last post February 13, 2015, 04:43:21 PM
by Michael_L
NHD-2.4-240320CF-CTXI#-FT (ST7789S controller) and STM32F4 FSMC LCD Interface

Started by deshayesBoard TFTs

Replies: 1
Views: 4237
Last post March 17, 2016, 06:25:18 PM
by fahad
7.0" TFTs with capacitive Touch and 8080 interface availability?

Started by gdoraisaBoard TFTs

Replies: 1
Views: 2859
Last post June 30, 2016, 07:54:11 AM
by Saurabh_B