Author Topic: connection  (Read 4294 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
« on: July 14, 2014, 11:24:00 AM »
Good day. :D
I begin to work with display NHD-2.4-240320SF-CTXI#-F1, i don't understand how i must to connect the display with the microcontroller.  There are the possibility of i do the connection  with a microcontroller ATxmega128D4 or i need a microcontroller with a compatible controller display.
Which is the best form of i do to connect the display, with connection interface 8080, 6800 or SPI with this microcontroller.
I apologize for my english and thank you response.


  • Administrator
  • Hero Member
  • *****
  • Posts: 357
  • Karma: 34
    • View Profile
Re: connection
« Reply #1 on: July 15, 2014, 09:03:28 AM »
That display will only work with the 8080 mode interface, so you would connect to your micro as such.  To know what to connect, you would use the pinout table on page 4 of the datasheet, and wiring diagram on page 5.  These will show you exactly how to connect this display to your microcontroller.  The micro you have listed should work fine, as long as it has an 8-bit parallel data port, and other available GPIO to drive the control signals of the display.


NHD-0216SZ-FSW-FWB incorrect connection

Started by moeedmughalBoard Character LCDs

Replies: 5
Views: 5166
Last post May 01, 2015, 09:50:04 AM
by Paul_B
SPI connection and initialization of NHD-C12864A1Z-FSW-FBW-HTT

Started by nicoBoard Graphic LCDs

Replies: 1
Views: 4363
Last post April 28, 2016, 08:31:38 AM
by Saurabh_B
SPI connection to NHD-C12832A1Z-FSR-FBW-3V3

Started by raspdroidBoard Graphic LCDs

Replies: 1
Views: 4868
Last post January 29, 2016, 09:29:52 AM
by Saurabh_B