Author Topic: NHD‐C0220AA‐FSW‐FTW Contrast  (Read 4620 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
NHD‐C0220AA‐FSW‐FTW Contrast
« on: February 25, 2015, 06:14:11 PM »
I am using the NHD‐C0220AA‐FSW‐FTW and it works great on my first board.  I am trying to get a second board up (same PCB design, same software), but the nothing come on the LCD.  I think that it's a contrast problem but no matter what voltage I put on pin #2 (3.3V down to .013V) I can't see my text.  Here are the voltages on my pins:
1. 0V (gnd)
2. adjustable, but trying 0.1V and lower
3. 3.3V
4. Mostly 3.3V (brought low during instructions, but defaults at high)
5. 0V (gnd)
6.  Mostly low, brought high during messages
7-14. Parallel message.

Any ideas on what i should try?


  • Guest
Re: NHD‐C0220AA‐FSW‐FTW Contrast
« Reply #1 on: March 03, 2015, 11:53:43 AM »
For pin 6, you should start at high and then bring it low during messages.  The timing diagram on page 8 of the specification sheet shows how the Enable pin (E) should go high first and then low.  Also if you are checking the busy flag during initialization, it is recommended to use a delay instead because this controller is known to have issues with the busy signal as noted on page 5 of the specification sheet.


Setting contrast using component pads on LCD module - NHD-24064WG-ATMI-VZ

Started by ngatgiBoard Graphic LCDs

Replies: 1
Views: 2993
Last post April 04, 2018, 07:08:38 PM
by ngatgi
Display NHD-C12864WO-B1TFH#-M contrast options.

Started by craig@oregonembedded.comBoard Graphic LCDs

Replies: 1
Views: 218
Last post October 28, 2019, 01:43:00 PM
by Alee_S
NHD-7.0-800480EF-ASXN#-T Bad contrast, background too bright

Started by wilfridBoard TFTs

Replies: 0
Views: 87
Last post November 12, 2019, 12:00:39 PM
by wilfrid
NHD-2.7-12864UCY3 brightness/contrast adjusting

Started by EK701Board OLEDs

Replies: 3
Views: 6533
Last post January 28, 2016, 09:51:31 AM
by Saurabh_B
software controlled contrast is not consistent

Started by pabbottBoard Character LCDs

Replies: 2
Views: 4448
Last post September 10, 2015, 02:17:08 PM
by pabbott