Author Topic: Using NHD-1.69-160128UGC3 CPU and PS signal  (Read 4503 times)


  • Newbie
  • *
  • Posts: 2
  • Karma: 0
    • View Profile
Using NHD-1.69-160128UGC3 CPU and PS signal
« on: April 10, 2015, 05:07:59 PM »
Hi, I have running the display very successfuly using the serial interface, a MEGA Aduino and your sample code. I am now trying to get it switch to 8080 parallel mode and having difficulty.  In the application note, the signals CPU and PS are tied to GND and 3.3V respectively, but in the sample code toggles these lines in the case of 8080 parallel.

Can you tie these as shown in the app note and comment out the logic for the CPU and PS in the code?



  • Administrator
  • Hero Member
  • *****
  • Posts: 357
  • Karma: 34
    • View Profile
Re: Using NHD-1.69-160128UGC3 CPU and PS signal
« Reply #1 on: April 22, 2015, 11:44:34 AM »
Those pins are used to select the interface you would like to use.  They can be either fixed (tied to VDD/GND accordingly) or connected to GPIO and toggled appropriately in software.


NHD‐3.5‐320240MF‐ATXL#‐T‐1 Touch Signal

Started by jmasamotoBoard TFTs

Replies: 1
Views: 6769
Last post February 05, 2016, 08:05:40 AM
by Paul_B
NHD-1.69-160128UGC3 how avoid tearing artefacts ?

Started by emax73Board OLEDs

Replies: 2
Views: 4881
Last post March 11, 2016, 12:50:09 PM
by emax73
Current consumption NHD - 1.69 - 128160ASC3 and NHD -1.69- 160128UGC3

Started by NickBoard OLEDs

Replies: 1
Views: 4072
Last post June 16, 2016, 08:04:03 AM
by Saurabh_B
Connector hole size in NHD-1.69-160128UGC3

Started by VRTBoard OLEDs

Replies: 2
Views: 3184
Last post November 18, 2016, 06:33:59 AM
by VRT
Smooth Scrolling on NHD-1.69-160128UGC3 with SEPS525

Started by pixelBoard OLEDs

Replies: 0
Views: 2921
Last post July 06, 2017, 08:35:54 PM
by pixel