Author Topic: NHD‐2.23‐12832UCB3 I2C WontTurn ON  (Read 1957 times)

NHD2.23_I2C

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
    • View Profile
NHD‐2.23‐12832UCB3 I2C WontTurn ON
« on: April 05, 2015, 05:33:02 AM »
HW Config:
SA0 is permanently pulled low.
/Res is permanently pulled HIGH. Not sure if this pin needs to be delayed for module to work.
All rest of connections were made properly.

I send the commands as in the attachment and wanted to make sure that device is being initialized properly.

void DISP_WrCmds (UINT8 DispAdr, unsigned char Ctrl1, unsigned char Reg, unsigned char Ctrl2, unsigned char Val);
[7bit device ID+Wr BIT] then [control Bit of 0x00] then [Register 0xFD] then [0x40] then [0x12] for UNLOCKING
....send other init sequences eg Set Display clock, Set Mux Ratio, Set Display Offset, Set Start line
...
[7bit device ID+Wr BIT] then [control Bit of 0x00] then [Register 0xAF] for TURN ON device.

see attachments for clarity.

Does this look correct especially the control bits for command and data.
If all looks okay, Any suggestions why display is not coming ON.
« Last Edit: April 05, 2015, 02:51:41 PM by NHD2.23_I2C »

 

Calculation of Font Addresses Multi‐Font Displays Help!

Started by BluesboyBoard OLEDs

Replies: 6
Views: 3718
Last post September 11, 2015, 10:54:16 AM
by Saurabh_B
Writing Messages with NHD-2.23-12832UCB3

Started by SLTom992Board OLEDs

Replies: 1
Views: 2630
Last post July 31, 2014, 08:40:08 AM
by Michael_L
NHD-2.23-12832UCB3 memory display

Started by movesystemsBoard OLEDs

Replies: 1
Views: 2119
Last post January 23, 2015, 09:48:21 AM
by Michael_L
NHD-2.23-12832UCB3 C Library

Started by SLTom992Board OLEDs

Replies: 5
Views: 4361
Last post July 18, 2014, 10:59:16 AM
by Michael_L
NHD‐0216PZ‐FL‐YBW

Started by oldhippyBoard Graphic LCDs

Replies: 1
Views: 2275
Last post January 23, 2015, 09:37:27 AM
by Michael_L