Author Topic: NHD-0216K3Z-FL-GBW-V3-C serial interface not working  (Read 3189 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
NHD-0216K3Z-FL-GBW-V3-C serial interface not working
« on: July 13, 2015, 02:27:30 PM »
I hooked two of these displays up to RS232 at 9600 and get a bunch of junk characters. To test my output stream I routed the serial output to hyperterminal and the stream is correct. I tried changing the baud rate to everyone listed in the data sheet and still a bunch of junk. These displays all show evidence of once being setup, before I received them, for I2C because there is solder and flux on and around the R1 pads.

Any advise?


  • Administrator
  • Hero Member
  • *****
  • Posts: 383
  • Karma: 10
    • View Profile
Re: NHD-0216K3Z-FL-GBW-V3-C serial interface not working
« Reply #1 on: July 14, 2015, 08:49:25 AM »
I was wondering if you would be able to confirm that both R1 and R2 are open on the back of the display. Also for this display the RS232 communications are supposed to be at TTL Logic levels, can you also confirm that this is what you are using for the communication.


NHD‐0420CW‐AB3 I2C Interface

Started by andersonpdBoard OLEDs

Replies: 1
Views: 4910
Last post January 23, 2015, 10:00:06 AM
by Michael_L
NHD‐0420DZW‐AY5 SPI Interface

Started by vinaykBoard OLEDs

Replies: 0
Views: 3841
Last post October 26, 2015, 05:13:10 AM
by vinayk
NHD‐3.12‐25664UMB3 3 or 4 wire interface

Started by cliffgBoard OLEDs

Replies: 1
Views: 4186
Last post February 13, 2015, 04:43:21 PM
by Michael_L
NHD-2.4-240320CF-CTXI#-FT (ST7789S controller) and STM32F4 FSMC LCD Interface

Started by deshayesBoard TFTs

Replies: 1
Views: 5345
Last post March 17, 2016, 06:25:18 PM
by fahad
7.0" TFTs with capacitive Touch and 8080 interface availability?

Started by gdoraisaBoard TFTs

Replies: 1
Views: 3934
Last post June 30, 2016, 07:54:11 AM
by Saurabh_B