Author Topic: NHD-4.3-480272EF-ATXL#-T FFC Connector  (Read 3959 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
NHD-4.3-480272EF-ATXL#-T FFC Connector
« on: August 27, 2015, 05:40:28 PM »
In the NHD-4.3-480272EF-ATXL#-T Datasheet it shows the recommended LCD connector on page4 to be a Molex p/n: 54132-4097 but on the NHD web site it shows a Molex 54104-4031 to be used with this display. I see they are almost the same but the first one is a Bottom contact and the second is a top contact. Which one should I use? I can't find any of the 54132-4097 but I have found a compatible alternative bottom contact 54132-4062. Will that work?


  • Administrator
  • Hero Member
  • *****
  • Posts: 384
  • Karma: 10
    • View Profile
Re: NHD-4.3-480272EF-ATXL#-T FFC Connector
« Reply #1 on: August 28, 2015, 08:08:37 AM »

Either the 54104-4031 or the 54132-4062 will work just fine, The deciding factor is where you would be likely to mount the display. On our controller they use a top contact FFC connector because it is often attached onto the bezel of the display.


NHD‐3.5‐320240MF‐ATXL#‐T‐1 Touch Signal

Started by jmasamotoBoard TFTs

Replies: 1
Views: 6965
Last post February 05, 2016, 08:05:40 AM
by Paul_B
NHD‐3.5‐320240MF‐ATXL#‐CTP‐1 Problem with standby mode

Started by guenterBoard TFTs

Replies: 0
Views: 6970
Last post June 16, 2016, 12:14:36 PM
by guenter
NHD-5.0-800480TF-ATXL#-T and NHD-5.0-800480TF-20 Controller Board No Touch?

Started by dfanslerBoard TFTs

Replies: 5
Views: 8312
Last post May 26, 2017, 11:10:57 AM
by Saurabh_B
NHD-5.0-800480TF-ATXL#-CTP why don't typical timing values work?

Started by jkelleherBoard TFTs

Replies: 2
Views: 6600
Last post August 31, 2015, 05:08:45 AM
by jmag999
NHD-3.5-320240MF-ATXL#-CTP-1 Ft5x06 Linux device tree

Started by rajarajan.rBoard TFTs

Replies: 1
Views: 6703
Last post July 05, 2016, 01:21:43 PM