Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - samiam208

Pages: [1]
Character LCDs / Re: I2C Controller (PIC16F960) more detail needed
« on: June 18, 2014, 09:23:16 AM »
I got it now.

Character LCDs / I2C Controller (PIC16F960) more detail needed
« on: June 10, 2014, 10:25:10 PM »
I am trying to use a Serial LCD Character Display with the PIC16F690 controller in the I2C mode. I am writing a bit-bang assembly code program.  I cannot find sufficient info to accomplish the I2C protocol for this controller.  What is the sequence I use to send ASCII characters to be displayed? Will this work?-- Start, Device address, ASCII Byte,……..more ASCII Bytes, Stop?  The “Table of Commands” does not show any Prefix or command for displaying characters and does not show anything for multi-character(byte) transfers.  The Data Sheet for the controller is just the generic PIC and does not help.  Are there any documents that detail the I2C interface?  You know the kind of detail that is shown for an I2C EEPROM or RTC.  The exact display I am trying to use is NHD-0216K3Z-NS(RGB)-FWB-V3.

Pages: [1]