Newhaven Display Forum

Newhaven Products => TFTs => Topic started by: jack1234 on December 14, 2015, 02:00:22 AM

Title: DE mode for NHD-7.0-800480EF-ATXL#-T
Post by: jack1234 on December 14, 2015, 02:00:22 AM
Can the NHD-7.0-800480EF-ATXL#-T display be operated in DE mode, ignoring V and H sync?  If so, do I tie V and H sync high or low?

The HX-8264 controller has a pin to select DE mode or SYNC mode, but your datasheet does not indicate which mode is enabled.
Title: Re: DE mode for NHD-7.0-800480EF-ATXL#-T
Post by: Saurabh_B on December 14, 2015, 08:22:03 AM
Hi Jack,

By default the display is already in DE mode, to put the display into Sync mode, you would need to short the R4 jumper on the FPC below the display.
Title: Re: DE mode for NHD-7.0-800480EF-ATXL#-T
Post by: jack1234 on December 14, 2015, 01:00:39 PM
Thanks for the information.  We prefer DE mode because we are using our own custom FPGA graphics controller and DE mode permits eliminating a lot of blanking time and therefore a lower clock frequency.

Is there any documentation of the R4 jumper?  I couldn't find it on the datasheet.