Newhaven Display Forum

Newhaven Products => TFTs => Topic started by: MD_MN on November 10, 2014, 11:52:35 AM

Title: DKSB1014B with PIC24FJ256DA210 development board
Post by: MD_MN on November 10, 2014, 11:52:35 AM
Do you have a document that has the LCD initialization values for the DKSB1014B (DigiKey's development board for the 3.5" display)?
Thanks much.
Title: Re: DKSB1014B with PIC24FJ256DA210 development board
Post by: Michael_L on November 11, 2014, 03:05:10 PM
The below link should have everything you need:

http://www.eewiki.net/display/Motley/PIC32+Low-Cost+Controllerless+Graphics+Interface+to+Newhaven+Color+LCD (http://www.eewiki.net/display/Motley/PIC32+Low-Cost+Controllerless+Graphics+Interface+to+Newhaven+Color+LCD)
Title: Re: DKSB1014B with PIC24FJ256DA210 development board
Post by: MD_MN on November 13, 2014, 02:30:52 PM
I do not see any code examples that will run on the MicroChip PIC24FJ256DA210 Graphics Development Board.
Do you have any code available for that development board?

Thanks.
Title: Re: DKSB1014B with PIC24FJ256DA210 development board
Post by: Michael_L on November 14, 2014, 09:38:53 AM
https://www.eewiki.net/display/Motley/Interface+PIC24+to+Newhaven+QVGA+Color+LCD+Touch+Display (https://www.eewiki.net/display/Motley/Interface+PIC24+to+Newhaven+QVGA+Color+LCD+Touch+Display)
Title: Re: DKSB1014B with PIC24FJ256DA210 development board
Post by: MD_MN on April 06, 2015, 09:40:19 AM
Just getting back to this project. I'm writing the code in assembly. I see the proper settings for the internal registers on the DA210, but I do not see the initialization values that need to be sent to the Newhaven display module via SPI on power-up. Can you tell me what file those are located in?

Thanks much.