Newhaven Display Forum

Newhaven Products => Graphic LCDs => Topic started by: jaredmny on March 17, 2015, 11:39:56 PM

Title: NHD-C12832A1Z-FSW-FBW-3V3 1.5mm header
Post by: jaredmny on March 17, 2015, 11:39:56 PM
Hello,
I recently purchased the display mentioned above and found that it has a 1.5mm spaced header. Do you have a recommended part number for a mating socket? Alternatively, do you have an adapter / breakout board available for prototype development work? 
Thanks.
Title: Re: NHD-C12832A1Z-FSW-FBW-3V3 1.5mm header
Post by: Paul_B on March 18, 2015, 07:54:55 AM
Hello,

Thanks for reaching out, NHD-C12832A1Z-FSW-FBW-3V3 is meant to be soldered directly to a pcb. We sell a 17 pin Thru-hole to 2x4 Conversion board for NHD-C12832A1Z displays. All necessary capacitors for the voltage booster-circuit and current limiting resistor are included. Please see the link below  8)

http://www.newhavendisplay.com/nhdpcb12832a1z-p-3569.html

Hope this helps!
Title: Re: NHD-C12832A1Z-FSW-FBW-3V3 1.5mm header
Post by: bkulpa on April 05, 2016, 02:22:31 PM
We have been using this display for the past three to four years and have noticed that after this time the display back light begins to dim.  Is this expected behavior?  Is there anything we can do to make the back light brighter?