Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - mnauss

Pages: [1]
OLEDs / Re: NHD-2.7-12864UMY3 Mechanical Info
« on: September 05, 2015, 01:18:30 AM »
Thanks, I been doing others task lately so I got sidetracked on the display portion. I am once again looking into the display issue. The displays you mentioned above do not have the right form factor for me and I do not need color. One display that I thought might work is the NHD-12864WG-BTMI-V#N, or this one NHD-12864WG-BTFH-V#N-ND The image looks like a bright display and is about the size of a business card, which is good. Do any of these work well in sunlight? I do not have much experience using display technology, so I am slowly getting up to speed.

Also, I was wondering how well the resistive touch screens work with gloved hands?

Thank you

OLEDs / Re: NHD-2.7-12864UMY3 Mechanical Info
« on: August 25, 2015, 02:48:05 AM »
Thanks, that image really clarifies things for me, and now I am not so sure that display will work out for me. Here is what I am doing and perhaps you might have a better idea what display would be more suitable. First, picture construction workers, and big burly guys using a handheld instrument. It can be used outdoors in sunlight or in a more darkened space. To be specific, I am working on a air gas monitor that will be used by both construction and general industry. The display has to be both easily readable, and very rugged (again think big burly guys). If a touchpad can meet the physical demands, then that would be great as it really simplifies the mechanical part, and size.

Can you make any suggestions?

Thanks a bunch

OLEDs / NHD-2.7-12864UMY3 Mechanical Info
« on: August 21, 2015, 09:12:48 PM »
Greetings, I am using the NHD-2.7-12864UMY3 OLED display in my design. I am also in the process of creating my CAD symbols, schematic and PCB for the design. Now with the above mentioned part, it is not clear to me how this part is mechanically attached to the circuit board. In the data sheet I see what looks like 22 pin through holes. Now is this a connector or what? Do I need to use a molex or some such? Can you please advise. I am just unclear how this part attaches to my circuit. For my PCB CAD symbol should I just layout for something like a SIP 22, and what about any other mounting considerations like mounting holes, etc.
One more thing, I am having a hard time reading the verification images required to make a post and I am using a 25 inch monitor.

Thank you in advance for any assistance.

Pages: [1]