Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - erps

Pages: [1]
1
I need a Digital controller board for 5.7in TFT displays. 3.3V input. 16-bit parallel MCU interface.

Controller/Driver: SSD1963-16bit

I guess the part number would be NHD-5.7-320240WFB-34 Controller Board ????

I couldn't find it on the website?
Can you quote?

Thanks,

2
TFTs / Re: Vertical colored lines
« on: January 23, 2015, 08:27:17 AM »
Nothing in particular with the initialization code itself but where this code was place. I am using some ST code examples using the STemWin library and I was placing the initialization code in the wrong spot.

3
TFTs / Re: Vertical colored lines
« on: December 22, 2014, 09:32:34 AM »
It was an initialization issue. Once the correct initialization code was set on place the display start working.

4
TFTs / Re: Vertical colored lines
« on: December 17, 2014, 10:24:56 AM »
Thanks, it works now but still an issue during power on. Sometimes the display doesn't come up after a power cycle. I have to try several times either power cycling it or reset the board, for the display to come alive.
Is there any particular signal sequence during power on we need to consider?
Thanks,

5
TFTs / Vertical colored lines
« on: December 04, 2014, 12:44:02 PM »
Hi:

As a general question, what would be the reason to get vertical colored lines on a display? (see attached)
I am using NHD-5.7-320240WFB-ETXI #-T-1 with SSD1963 controller board.
Display is connected to the STM3221G-EVAL board from ST, FSMC 16-bit interface. I checked the connections and everything looks ok.

Thanks,

6
TFTs / NHD-5.7-320240WFB-ETXI #-T-1
« on: December 03, 2014, 11:36:02 AM »
Hi:

Need code example to drive the TFT display NHD-5.7-320240WFB-ETXI #-T-1 using the SSD1963 controller board.
I am using a STM32F2 microcontroller using FSMC 16-bit interface.
Can you help?
Thanks,

7
TFTs / Re: NHD-5.7-320240WFB-ETXI #-T-1-ND
« on: October 16, 2014, 09:06:29 AM »
I am going to use the interface board NHD-FFC36-ND.
Can you provide dimensions on that board?
Distance between Mounting Holes?
Thanks,

8
TFTs / NHD-5.7-320240WFB-ETXI #-T-1-ND
« on: October 15, 2014, 11:02:03 AM »
Hi:

I need a 32-position flat flex ribbon cable to connection the signals from the display to the uC board.
Do you provide for that?

Another question, the datasheet on page 4 shows connector CON2 as the interface connector. However, on the board it is shown as CON3 (picture attached), which one is correct?

Thanks,

Pages: [1]