Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - emilzacharia

Pages: [1]
TFTs / Re: NHD-5.0-800480TF-ATXL-CTP: Image distorted at certain regions
« on: September 14, 2017, 02:30:04 AM »
Attaching the other images separately due to size constrain.

TFTs / NHD-5.0-800480TF-ATXL-CTP: Image distorted at certain regions
« on: September 14, 2017, 02:28:55 AM »
We're using NHD-5.0-800480TF-ATXL-CTP for our Korsan(Wifi Display) project.

When we applied the clock and data as described in the timing diagram in page#12, the image displayed by the LCD was distorted in some regions(see DISTORTED.JPEG ).
The data change is in the rising edge of the clock as required.
See tek00087.png of the pixel clock and a signal below(Dark blue:Clock, Light Blue:Data)

After several debugging steps, when the clock was inverted using a NOT Gate externally and applied to LCD, the image was displayed fine ( see OK.JPEG ).
The pixel clock and a data line in this case is shown in tek00088.png. You can see the data transition occurring in falling edge of clock.

Also, the minimum setup time and hold time is specified as 8ns in Page#10.
Based on the given data, we could infer that the data is sampled on the falling clock edge.

This required setup time and hold time are properly followed in the first case where we got distorted image.

In the PCLK inverted case, this setup time and hold time seem to be improper, but we got clear image.

Please advise us wrt setup and hold time times described in your datasheet and what we observed in LCD.

Thanks in Advance.

TFTs / NHD-7.0-800480EF-ASXN#-CTP: Nominal Backlight Current
« on: February 15, 2017, 01:02:23 AM »
Can anybody please tell what is the nominal current consumed by NHD-7.0-800480EF-ASXN#-CTP backlight leds at normal brightness.
From the datasheet I know that the maximum is 180mA.
But, I want to know the normal value.

Also, will 80mA be enough for proper backlight.

Emil Zacharia George

TFTs / NHD-5.0-800480TF-ATXL#-CTP : Capacitive Touch Interrupt.
« on: February 06, 2017, 03:16:36 AM »
Pin# 5  of Capacitive Touch Panel is named as  /INT . It is described as an interrupt signal from touch panel module to host.
1. Is it an active High signal or an active low signal?
2. What is its functionality?

Pages: [1]