Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ciccone

Pages: [1]
1
Hello
I am using CTP with controller FT6236 - I can get read registers over I2C and also get touch point co-ordinates (x,y values) also can get how many touch points - i.e. 1 or 2. But I am not able to get gesture ID - it always returns 0, I need to get single finger touch gestures like move up, move down, move left, move right or two fingers touch zoom in or zoom out. How can I get this? Are there any register settings that I am missing?
Thanks in advance..
Silas

Hi Silas, I hope you're still around. I'm trying to use the FT6 controller too, did you get it to work?

Pages: [1]