Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - blaubaer

Pages: [1]
1
OLEDs / NHD-0420CW-AG3 MPU Interface Pin Selection and Power Supply
« on: March 01, 2015, 07:07:12 AM »
Hi,

for 8-bit parallel 6800 interface mode the NHD-0420CW-AG3 display spec shows for pin BS0 = 0, BS1=0 and BS2=1 - can I connect BS0 and BS1 to ground and BS2 to +5V to switch the display into the 8-bit parallel 6800 interface mode? Do I need pull up/pull down resistors - with which value?

For +5V power supply I've to connect +5V to pin 3 and let pin2 without connection, right?

Thanks and regards,
Michael

Pages: [1]