Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jandrade

Pages: [1]
1
Evaluation Tools / Unable to detect NHdev board target using J-link
« on: February 16, 2017, 10:22:28 AM »
Hello. I am trying to re-program the NHdev board but the target is not being recognized using J-link from SEGGER. The touch screen display is working fine and I am able to see the images loaded from the SD card. I was able to successfully use the J-Link on another board (not from New Haven) with no problems. Here's the equipment I have.

  • NH Development Board w/ STM32F103RET6 ARM 32 bit Cortex-M3
  • NHD-2.4-240320CF-CTXI#-FT
  • SEGGER J-Link Base programmer

Here's a screenshot from the J-link command. You can see the version of Jlink being used.



http://imgur.com/Rz2APHD


As you can see, it cannot detect the target. I tried scanning the target using MDK Keil uVision 5 as well but same result. Any feedback would be appreciated.

Pages: [1]