Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - parsec

Pages: [1]
1
OLEDs / Re: NHD-1.5-128128UGC3 + Beaglebone Black
« on: September 18, 2015, 06:47:56 AM »
Hi Paul_B,

Thanks, definitely a good starting point! I coincidentally discovered BBB iolib a few hours after posting my question here but wasn't sure if it was usable in this context.

I see in the comments section some guy Paul with a Newhaven display being addressed by the author. Was that perhaps you?  :) Did you have any success in getting it to work in the end?

Quote
You will need to modify the initialization sequence and other various parameters if you would like to use NHD-1.5-128128UGC3

Any idea where I can find more information about this?

2
OLEDs / NHD-1.5-128128UGC3 + Beaglebone Black
« on: September 17, 2015, 10:01:25 AM »
I'm about to wire up my newly acquired NHD-1.5-128128UGC3 to a Beaglebone Black using 3 or 4-wire serial. Wondering if anyone can point me to any C/C++ code that demonstrates basic initialization and communications under Debian, or any Linux distro for that matter? Or any C/C++ code that could easily be ported to compile under gcc?

Googled a lot on this and having a hard time finding good tutorials. I want to learn and know what I am doing, in what order things have to be done to make it work properly, not just copy-pasting stuff. Found some Arduino code on this website but tbh the code structure and commenting leaves a lot to be desired.

Thanks!

Pages: [1]