Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Swemarv

Pages: [1]
Character LCDs / Re: Issue with reading busy flag in 4 bit mode.
« on: October 07, 2014, 02:32:20 AM »
On page 5 in the LCD spec there is a link to the driver specification. on page 23 in the driver specification you can see that the high nibble  should be put out first.
See attachment.

[attachment deleted by admin]

Character LCDs / Re: Issue with reading busy flag in 4 bit mode.
« on: October 01, 2014, 07:16:43 AM »
Since this forum is linked from Newhaven site, I assumed that any product support related questions would be answerd in this forum.

I need an explanation for the strange behaviour of my LCD.
Can anybody help me out ?

Character LCDs / Issue with reading busy flag in 4 bit mode.
« on: September 29, 2014, 01:54:24 AM »

I have a NHD-C0220AA-FSW-FTW display that I have problems reading the busy flag from in 4 bit mode. To understand what is going on I connected my logic analyser to the datalines and the controll lines.

As I understand the datasheet of the controller, when reading the busy flag ( and the address of the AC) the high nibble is sent from LCD first and then the low nibble. But when I look what is on the datalines it looks like the low nibble is sent first and then the high nibble

I implemented this into my program where I do a clear and then wait for bysy flag to send a number of characters, and suddenly it worked.
I did a measurement just after a clear command, according to data sheet this should take 1.64ms.

I have attached two figures.
First directly after clear command, cursor one is positioned at the falling edge of second enable signal.
I read the data 1us after the enable has been set to one. It is clear that the first nibble sent by the LCD is not with the busy flag set (D7) when it should, but the second nibble has the D7 set.

After about 1.6 ms D7 finaly goes low, this corresponds well with the specified time after a clear.

it is also possible to read the AC after characters are sent, and it counts up as it should if I interpret the first nibble sent from LCD as the low nibble and not the high as is specified in the datasheet.

I manage to get the code working when implementing this change but I feel reluctant to use it since it is not according to the datasheet.
Does anyone have experienced the same thing or have a solution or suggestion on what I am doing wrong ?


[attachment deleted by admin]

Pages: [1]