Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ih55t

Pages: [1]
1
I've been using the NHD‐0108HZ‐FSW‐GBW display with success using Arduino hardware and IDE. However, there are 4 segments (large arrows) at the bottom of this display that I can't seem to control.
The data sheet says the segments start at address 0X40. They also list them as 0X40-A1 through 0X40-A4. I don't understand what the A1 means. Additionally, I don't know how to access 0X40. Apparently, I'm lacking a fundamental understanding of the addressing scheme. Any thoughts or direction?

Thanks -

Pages: [1]