Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - durian

Pages: [1]
1
TFTs / Re: Reading display memory
« on: August 07, 2015, 11:41:09 AM »
Thanks. It's nice to know I'm not crazy.

I've been over the ILI9340 manual from your site a few times, but I can't find anything that would suggest this sort of behavior is possible. Can you point me to some documentation that shows how the 16-bit input data is expanded to 24-bits before being stored in memory? Maybe there is a similar setting that will instruct the controller to squeeze the pixel data back down to 16-bits when read.

mike

2
TFTs / Reading display memory
« on: August 06, 2015, 06:15:25 PM »
I've been using an NHD-2.4-240320SF-CTXI-1 in a product for a few years now. I can write to the display using a 16-bit parallel bus without any problem. The display shows what it should. However, I've never been able to read the memory correctly. This hasn't been critical for us, but I decided to dig into it a bit today.

It appears when I write 16-bits, I read the data back in a 24-bit format. For example, if I write:
0001 fffe
I read back:
0000 08fc fcf4

It looks like RGB 565 packing:
Write (binary):
rrrrrggggggbbbbb rrrrrggggggbbbbb
Read (binary):
rrrrrXXXggggggXX bbbbbXXXrrrrrXXX ggggggXXbbbbbXXX

The X's are typically 0, but not always. Sometimes the highest order X bit in the R and B values is a 1. I'm not sure what the pattern is.

Does anyone have any ideas why I'm getting this asymmetric  read/write behavior?

Thanks,
mike



Pages: [1]