Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - gnyturan

Pages: [1]
1
Character LCDs / NHD-0420H1Z-FL-GBW-33V3 - 2 Lines Mode Problem
« on: October 24, 2015, 07:37:01 PM »
Hello everyone,

I am using NHD-0420H1Z-FL-GBW-33V3 with NXP LPC1774 an coding in C. When I initialize the LCD as described in the datasheet I cannot display anything, but if I try to use it in 1-line mode, it displays characters to the 1st and 3rd lines only.

So far, I tried:
- 3 (and more) wake up calls with 0x30 and then sending 0x38
- Putting exaggerated delays between init commands
- working in 1-line mode and addressing with 2-line addresses (0xC0 command for second line)
- using another unused screen

If anywhere in the code I use 0x38 command, I get blank screen.

If anyone had the same problem and/or knows the solution could you please help me with this.
Thank you very much in advance,
Kind regards
Gunay

Pages: [1]