Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jmcpherson

Pages: [1]
1
TFTs / Re: CS for NHD-3.5-320240MF
« on: June 17, 2016, 11:10:53 AM »
We can support 16 bit parallel, it was the 24bit that was the issue.

How do I connect the data lines to make 16bit work?

James

2
TFTs / Re: CS for NHD-3.5-320240MF
« on: June 17, 2016, 10:56:35 AM »
Thank you.  :)

3
TFTs / CS for NHD-3.5-320240MF
« on: June 16, 2016, 10:47:18 AM »
We are evaluating the NHD-3.5-320240MF for a new product.  We want to use the 8-bit parallel mode, but we are confused on what to use for the Chip Select [CS] for the Display.  There is the Data Enable pin [DEN] but that is apparently a no connect.  What do we use so we know that the right data is on the bus at the right time?

James McPherson
Senior Electrical Design Engineer
Sandhill Scientific

Pages: [1]