Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - shree97

Pages: [1]
1
TFTs / Display is Not showing anything
« on: July 03, 2016, 06:29:16 AM »
Hello ,
         I am trying to interface NHD-7.0-800480EF-ATXL#-CTP  display with our custom i-Mx6 board .When I connected the Display its backlight is powering On but not showing anything on it .Also its becoming blurr lining on it.I am unable to understand the timing values from datasheet. But I tried with setting some values. O our board cmdline the fbset output is as follows:

mode "800x480-83"
    # D: 40.000 MHz, H: 42.553 kHz, V: 82.950 Hz
    geometry 800 480 800 480 32
    timings 25000 60 60 8 20 20 5
    rgba 8/16,8/8,8/0,8/24
endmode

So please help me in setting correct parameters.

Pages: [1]