Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dannyj

Pages: [1]
1
OLEDs / NHD-1.27-12896UGC3, can't write data correctly, 4 wire spi
« on: November 12, 2014, 04:53:58 AM »
Hi,
I am surveying a display module, NHD-1.27-12896UGC3. Currently I can only write commands to this controller correctly, Iíve verified sleep-in, sleep-out, display mode all-on, all-off, display mode normal. They are all correct. But when I tried to write a command and then write data to the controller, I found it usually doesnít work. In other words, it just works sometimes.

I am using 4-wire serial mode.
I put my waveform at the end of this mail. This is a Ďset column addressí command with 2 data, 0x14 and 0x17, I programmed. Iíve checked some sample programs, and they set SDIN as high before writing data. Does this make me canít write data into the controller correctly?
Does it need to delay some time between a command issued and start to write data?
Or does my SCLK not support for this display module?

Thanks for your help.

VDD: ~3V
SCLK: 1.5 MHz ~ 500KHz (Those I have tried)

ss-p9: CS#
sclk-p7: SCLK
mosi-p8-sio0: SDIN
miso-p5-sio1: D/C#
 

Pages: [1]