Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - control3

Pages: [1]
1
OLEDs / Re: NHD-0420DZW-AG5 OLED character module--Displaying junk data
« on: December 11, 2016, 11:19:54 PM »
Hi Paul,

Thanks for your reply.

We will try to make use of your suggestions to improve our design further.

Thanks,
Spandana

2
OLEDs / NHD-0420DZW-AG5 OLED character module--Displaying junk data
« on: December 07, 2016, 03:59:58 AM »
Hi,

We are using NHD-0420DZW-AG5 OLED character module for displaying system status and fault information.  We are using Serial interface for communication. Some times the data is getting corrupted and displaying some unintended data at unintended locations. This problem has been observed when the display is mounted above a SMPS where as it is not happened in other case. The data on the serial bus may be getting corrupted while transferring due to the induced/radiated noise from the SMPS.

Is there any recommendation for  pull up / pull down resistors  or capacitors on the serial interface lines to avoid the data corruption?
There is an inductive device L1 on the back side of the display. Can the induced noise in this device cause the data corruption?

Please suggest us to address this problem.

Thanks in advance,
Spandana

Pages: [1]