Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dCipher

Pages: [1]
1
Character LCDs / Get Cursor Position Command
« on: September 27, 2017, 01:58:29 PM »
Hi

I am using the Serial Liquid Crystal Display Module (4 lines by 20 characters).  It would be very nice if there was a command that would return the cursor position.  This would allow me to handle user input from the keyboard when the entry is more than 20 characters long.  Currently the data wraps to wrong line.  If I knew where the cursor was I could re-position it in those cases.

Thanks,
Simon

Pages: [1]