Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - tiro

Pages: [1]
1
TFTs / FT5336 problem with sensitivity and gesture
« on: October 16, 2017, 04:47:53 PM »
At first... hello all. I try to run display with this CTP but pdf are poor...
Now, small problem. Gesture register still give back 0, no matter what I draw by finger. It's normally?
And here is my big problem. I have three display, one work ok, but other two rages when I only touch it. FT cannot decide that I touch it by one or more finger, similar is with XY position. Is possible to adjust senstivity or change treshold point?

I find also pdf for FT5306 where I see register 0xA6h (firmware). In good module I see here 7, in bad is 6. But I'm not sure that is good way to read this register who I don't see in screen pdf (where is not write directly but is on FT5336)

Pages: [1]