Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jjbrewer

Pages: [1]
1
Character LCDs / Re: I2C ACK issue
« on: March 25, 2014, 05:21:39 PM »
I was able to insert the NXP PCA9605 between the COG LCD and the other devices and the ribbon cable.
I was able to use 10kOHM for the side the COG LCD is on and iw as abke to ACK quite well.
On the other side, the buffer was able pull it low even with the 1.5kOHM pullups I started that the PsOC and EPROM were okay with.

2
Character LCDs / Re: I2C ACK issue
« on: March 19, 2014, 12:49:14 PM »
The issue is I need it to work with these other devices at the end of a 36" ribbon cable at 100kHz.
I have attached a VISIO drawing and pictures from a O-scope of the wave forms. The 1.5K pictures are with the 1.5K pullups and the 20K are with 20K pullups.
The EPROM and PsOC have no issue pulling down the SDA with the 1.5K pullups.
I picked this COG because of its size. It was the only one I could find that will fit in the space I have.
My next experiment will be placing the NXP PCA9605 between the I2C bus and the COG.

The attachments button only allows 4 and won't send BMPs, so I zipped it up and changed the extension to pdf, rename to .zip

3
Character LCDs / I2C ACK issue
« on: March 18, 2014, 08:14:23 AM »
It was reported on the other forum that the I2C controller bounded to the NHD-C0216CiZ-FSW-FBW-3V3 COG character LCD could only sink 4ma of current.
In order to get a decent waveform with the cable length I am using I have 2.5K pulllups on my PCBA. The COG cannot pull SDA down hard enough for a valid ACK.
Would a NXP PCA9605 2 wire buffer, placed  between the COG and the other devices and cable, help?

Pages: [1]